MP Seclect Mini Extruder Lever Arm

thingiverse

This is a revised version of the Extruder Lever Arm cause on my MP Select Mini, with Cura Slicer, where the PIN was consistently too weak. The dimensions in the original STL file were also slightly off, being "too wide". I fixed this issue here. All credit goes to Zackattaks: http://www.thingiverse.com/thing:1743385 (Original File). An alternative version with a bolt can be found at: http://www.thingiverse.com/thing:1812623. Print Settings: Printer: Malyan M200 / MP Select Mini Rafts: Yes Supports: Doesn't Matter Resolution: 0.1 Infill: 80 Notes: It's recommended to avoid wrapping rafts on the Malyan M200 / MP Select Mini printer for better results. Post-Printing: Clean out the hole a bit. The part should fit snugly together.