Moza R9 table clamp

thingiverse

As the table clamp is hard to get a hold of I designed this simple jig to fix the Moza R9 base to my desk using glue clamps. Will get some C-clamps in the future if I don't switch to a more permanent wheel base. Should work just fine even though the R9 can generate 9Nm. Can be printed without supports, the holes seem closed, but this is to facilitate the overhang without support; just drill them out afterwards. I printed it at 15% infill (Cura - Gyroid setting) with 4 wall perimeters to make sure the screws have some solid material to bear on. Good luck!