Move Joystick Mod

thingiverse

This is the first version of the Move mounted Joystick mod. You will need an old or cheap third-party DualShock 4 to desolder the left joystick and use it for communication with the PlayStation later on. Still working on an easy way to mount the DS4 PCB with the AccuPack somewhere =/ What you need: One Move_Joystick_A printed One Move_Joystick_B printed One DualShock 4 One Move Controller Three M3x6mm screws Eight wires with 0.25mm^2 or less, long enough to connect the joystick on the move to your DS4 Optional: Plug-in connector for the cable to unplug the joystick if not needed Tools: Screwdriver for the DS4 (PH0) and the type of screws you are using One soldering iron with at least 60-80W A little bit of solder Double-sided tape or Velcro Build Instructions: !!! Be careful when disassembling the DualShock to not tear apart one of the connector cables of the controller!!! Disassemble the DualShock 4. After removing the four screws, it will still be attached by some snaps. If a snap or even all break during disassembly, don't worry; the screws will be enough to hold it together later on. You can also remove the rumble motors to make the DS4 lighter. Desolder the left joystick and solder the wires to the marked spots on the PCB. Optional: You can now build in the connector if you want. Put the DS4 back together (just follow the guide in reverse order). Now solder the other side of the wires to the pins of the joystick and watch out to make sure that the correct wires are soldered to the correct pins. The wires are now an extension of the PCBs to the joystick. Now insert the joystick into the two shells with the same direction it had on the PCB and use the three M3 screws to close the shell. The last step is to attach the shell to the Move Controller. Use double-sided tape to do that. The organic shape of the move controller was hard to replicate in the CAD program, so the shell does not fit perfectly. Use more double-sided tape in the center of the shell to make it fit perfectly and you are done. If you want to add the right joystick to the second Move as well, mirror the two halves of the shell and do it all over again.