Mouth Piece

thingiverse

This is a custom Mouth Piece for the Deadrabbit RDA. It may require some light sanding where it interfaces with the O-ring. Printing it upside down can help avoid using supports. Additionally, the plastic might deform if it gets too hot during printing, so consider using a lower temperature setting - you know your printer best. Printing time is approximately 35 minutes. Edit: The STL file was somehow oriented on its side, resulting in an awkward orientation. Edit2: I managed to find some time today and printed the mouth piece with 50% infill and .06 layer height. Unfortunately, it turned out slightly elliptical, weak, and smaller than expected. To improve the outcome, I will try printing at 100% infill, .15 layer height, and a slower print speed on my printer, which takes about 15 minutes. I'll post an update soon.