Mounting box printed with ApolloX for outside usage

youmagine

I built my own mounting box since I had an old video phone installed earlier where the wall opening / box no longer fit with my new one (Bticino - Linea 3000). This is just the first part, with more parts to come. I'm not sharing much about the design itself but rather the print result using a new material called ApolloX from Formfutura. Below are the settings I used and I was quite pleased with the results. There was no warping at all. I did notice a slight issue during creation of the brim - you can also see a crack in the picture - but it didn't affect the final print negatively. If this filament will withstand outdoor conditions such as rain, UV, heat, and cold, then it would be a very useful material! Thanks to @Tinkergnome for pointing this out!