Mounting Boards for Ethernet Smoothstepper & C25 Breakout Board & C41S PWM Speed Controller

thingiverse

This is a remix of https://www.thingiverse.com/thing:3288061 Mounting Boards for USB or Ethernet Smooth Stepper and C25 Breakout Board I've included the C41S - PWM Variable Speed Control Board mount which is new not a remix. The remix of the ESS & C25 mounts use 54% less filament than the original thing. 27572.8 mm vs 12745.4 mm The new C41s uses only 3275.2 mm of filament. The C25 mount is a better fit. I've shortened the front edge to allow the red LEDs to be seen better on the ESS. I've made the mount 1.25 mm thicker to make it fit better and take stress off the ESS when you screw down the C25. I've added tie down tabs to help in mounting them to your back plate. The ESS has a cutout in the front left corner for the power supply plug. The mounts have 2 mm holes, I've drilled them out and tapped them to fit 3 mm board mounting screws. The boards have 4 mm mounting holes but I choice to use 3 mm screws rather than 4 mm. On all 3 mounts the boards sit fine in the relaxed position. The original mounts the boards didn't sit comfortably on the mounts without needing to pull them down and stressing the boards. Let me know if you have any questions or comments. Thanks,