Mounting Block for Zonestar P802QS

thingiverse

The P80QS Zonestar boasts u-shaped rails on either side, extending from front to back for added stability - a notable improvement over its predecessors, which relied on rods. This mounting block allows users to securely fasten the P802QS to any table or board using standard wood screws without disassembling it. One side features a hole, enabling the block to be fitted snugly into the end screw and positioning it as close as possible to the end. As my first OpenSCAD design, I admit it may seem somewhat rudimentary but it functions effectively nonetheless. Note: In my setup, I use these mounting blocks at the rear of the Zonestar, while employing norton540's mounting blocks in the front - this configuration maintains a 220x220 printing area. You can find his designs here: http://www.thingiverse.com/thing:1778265/#files Printer Settings: Printer: Zonestar P802QS Rafts: No Supports: No Infill: 20% Notes: I used .8 for the top/bottom/walls; no supports were necessary.