Mountable shell for LED dimmer

prusaprinters

This is a common low-voltage LED dimmer available on Amazon, eBay, Ali Express, and lots of other places. It's intended to be just in-line with the power cable but I wanted to mount it. After a couple of double-sided-tape failures, I designed this.This replaces the back half of the dimmer body with one that has flanges and a better surface for mounting. The mounting screws are annoyingly right in line with the cable entrance/exit, but I wanted the symmetry and for the cable to sort of hide the screws.It's not a perfect fit, but it's good enough for me.Prints as shown without supports. There's a single layer (assuming 0.2mm layers) sacrificial bridge across the four assembly holes to facilitate a strong screw boss without requiring supports. Just jam the screws through the first time after printing and they'll clear it.