Mount tubes for Ar Wing

thingiverse

I usually secure rx-antennas at the wing's bottom on both sides. The rx-antenna then ripped off when the wing crashed. I reattach antennas to tpu tubes in the rear, forming a V-shape. The tubes are longer than needed. I punch holes, insert them from inside, and fasten with double-sided tape along the edge. Next, I bend the tubes towards the propeller and trim excess material to prevent damage. Finally, I insert the antennas and secure them with a small dab of glue. I print these parts using 98A TPU material. For symmetry, I mirror one set on my slicer. Additionally, I enable detect thin walls in my slicer settings.