Mount for VAWT by robotobi

thingiverse

I'm creating a modified version of the original VAWT mount designed specifically for robotobi's device. The primary objective is to install this mount on the edge of a large beam from our pavilion, necessitating some modifications to accommodate the new installation site. To facilitate this adaptation, I've created a revised design that incorporates four screws for secure attachment. Please note that the edges may appear slightly rough due to my 3D printer's limitations; unfortunately, it experienced frequent failures whenever I attempted to generate smooth curves. To minimize material usage and expedite printing, I recommend printing without supports and using a 30% infill ratio.