Mount for Full Graphic LCD Controller

thingiverse

January 22 I needed a straightforward mount to attach my new RepRap Discount Full Graphic Smart Controller to my FolgerTech printer. This isn't a situation that requires electronics casing, but it's something I'll get around to eventually. At some point, I'll tackle enclosing the electronics and tidying up the wiring, but that's a project for later. The corners of the controller board are pinched by the four bosses on the mount. I printed these without supports and did some filing to open up each corner groove. This mount is attached to the RAMPS / Arduino mounting panel with two M3 screws. Here's the design in OnShape. This project was for Pittsburgh's Fun a Day, 2017. Print Settings Printer: FolgerTech Prusa i3 2020 Rafts: No Supports: No Resolution: 0.5mm Infill: 20% Notes: I printed with Hatchbox ABS and cleaned up the corner grooves with a file after printing, as mentioned earlier.