Mount for 40mm fan and bl-touch mount

thingiverse

I am remixing the clamp from https://www.thingiverse.com/thing:2630027 based on https://www.thingiverse.com/thing:2099577, designed specifically to hold a 40mm fan - I am using a noiseblocker 40mm fan that is both cheap and extremely silent. This custom clamp also accommodates an original BL-touch. I am pairing the E3D clone with a height of 63mm (measured from top to nozzle tip, without push-fit) with the CarriageV2_3__63mm_AnetA8_E3Dv6_Mount.stl file from the original design. Additionally, I have included a genuine antclabs BLTouch, which fits perfectly in place. The needle is approximately 3mm above the print object when it is pulled up to its highest point. If you are using a 74mm clone instead of the E3D clone, this clamp will likely not fit properly. However, feel free to print and assemble it as instructed. You can then report back in the comments with information on how much lower or higher the mount for the BLTouch needs to be adjusted.