MotorPixie Board of Pray

thingiverse

Fun foamy airplane with forward swept wing design. Recommended setup: Wing: 5mm foam board, ideal for durability Fuselage: Construct with 3mm foam board; alternatively, use 5mm for added strength Wing tips: Fabricate using 3mm foam board; substitute 5mm for added stability Stabilizers: Use 3mm foam board or upgrade to 5mm for increased control motor mount: Employ ABS material or craft from cut 1.5mm plywood Rudder horns: Securely attach 1.5mm plywood Seal all openings with clear packing tape, providing water resistance Operate the airplane with a 6ch radio equipped with a CPPM receiver; alternatively, use PWM Power the airplane with two high-performance 2x 5g servos Install the ZMR 1804 2400KV Micro Size Integration Outrunner Brushless Motor Supply power using an 850mAh 45C 3S lipo battery pack Manage flight performance with the CC3D Evo flight controller, configured on Cleanflight Build Instructions: Print detailed PDF plans at a scale of 100%, carefully cutting and assembling onto 5mm or 3mm foam board. One A2 sheet is sufficient for careful assembly. To position the servos precisely, cut a piece of 55x12x5mm foam board to adjust their angle; ensure it fits snugly in place by adding a deliberate dent. Construct the airplane following the same steps as the Flitetest Mighty Mini Pun Jet, excluding the wing-folding feature: refer to videos on _I2W9Fdp45Q and f6QrnBglY6c. Secure additional support to withstand hard landings by inserting barbecue skewers into leading edges and between vertical stabilizers.