MotorPixie 2D gimbal for Phantom 2 Vision (FC200 and Gopro Hero 3(+) edition) - Discontinued

thingiverse

Discontinued - see http://www.thingiverse.com/thing:454791 instead. (You will be able to reuse some of the parts and electronics for building the MotorPixie 3D gimbal) 2D gimbal for: DJI Phantom (Body plate coming soon) DJI Phantom FC40 (Body plate coming soon - FC40 enclosure pending willing testers and specifications) DJI Phantom 2 (GoPro) DJI Phantom 2 Vision (FC200+GoPro) Build video coming up "shortly" 18/07/2014: Added Parts specifications PDF 19/07/2014: Added updated FC200 enclosure Added GoPro enclosure Added dampening screws 20/07/2014: Updated Parts specifications PDF with valuable input from the community Added updated controller enclosure (BaseCam case v7) for better printability and more room for the 3.5mm jack Added IMU case for Goodluckbuy (Martinez) IMU with pins that allow for easy removal. 24/07/2014: Updated GoPro enclosure and spanner to enable quick transition between FC200 and GoPro (IMU) Instructions See inclosed PDF document for detailed instructions! To complete this build, you will also need: 1x Basecam 2 axis controller board with IMU 2x Turnigy 2206-140Kv gimbal motors 8x M3x8 hex screws 8x M2x6 hex screws 8x M2 (4.8x0.3mm) washers (ADDED 22/6/2014) 2x M3x20 nylon screws 4x M3x16 screw 1x 3.5mm female 4 pole jack 1x 3.5mm male 4 pole jack with wires (90 degree angle) 1x 50mm 1 pin wire (pitch control) 6x rubber dampeners (50g/each) Mad soldering skills FC200 specific: 1x M3x16 screw 1x M3 nut GoPro Hero 3(+) specific: 2x M3x16 screw 2x M3 nut Plastic tubing to protect exposed FC200 jack (Next rev: additional 4x M3x16 screws, 4x M3 nuts - dampeners)