Motorized Heavy Duty Camera Slider

prusaprinters

<p>WIP!</p> <p>Heavy duty camera slider</p> <p>Designed for use with 25mm chromed steel pipes (<a href="https://www.bauhaus.se/dp-ror-millers-25mm-krom.html">https://www.bauhaus.se/dp-ror-millers-25mm-krom.html</a>) or Aluminium (<a href="https://www.bauhaus.se/ror-aluminium-o25mm-1m.html">https://www.bauhaus.se/ror-aluminium-o25mm-1m.html</a>)</p> <p>When printing, choose between Roller v6 (608 ball bearings) or v7 (688 ball bearings)</p> <p>Missing parts:</p> <ul> <li>might need some additional spacers on the top and bottom of the idler pulley</li> </ul> <p>Hardware:</p> <p>Nema 17 motor<br/> GT2 Timing Pulley, 20T M5<br/> GT2 Idler Pulley, 20T M5<br/> GT2 Belt, ~2M<br/> 8x 608ZZ bearings<br/> 1x 3/8" tripod screw</p> <p>4x M3x? (Motor attachment)<br/> 1x M5x? (idler pulley bolt)<br/> 1x M5 nut<br/> 4x M4x? (pipe attachment)<br/> 4x M4 nut<br/> 8x M4 washers<br/> 4x M5x50 bolts<br/> 8x M5 washers<br/> 8x M5 nuts<br/> 4x M5 locknuts</p> <h3>Print instructions</h3><h3>Category: DIY Print Settings</h3> <p><strong>Printer Brand:</strong> Creality</p> <p><strong>Printer:</strong> Ender 4</p> <p><strong>Rafts:</strong> No</p> <p><strong>Supports:</strong> No</p> <p><strong>Resolution:</strong> 0.28</p> <p><strong>Infill:</strong> 20%</p> <p><strong>Notes:</strong></p> <p>Experimental prints with these settings, seems sturdy enough...</p> <h3> Changelog</h3> <p><strong>Idler v8, Motor v9</strong></p> <ul> <li>Added 0.3mm to the holes for the pipe (now 25.3) </li> <li><p>Changed to M3 screwholes on the motorblock (incorrectly M5 on previous version)<br/> <strong>Added Roller v6, Camera carrige Top &amp; Bottom v5</strong></p> <p>New parts, needs to be tested</p> </li> <li><p>8 rollers halves needed</p> </li> <li>each roller is fitted with 2 608zz bearings, 2 M8 washer and 2 M8 nuts.</li> <li><p>bolt between top and bottom plates is M8x50<br/> <strong>Motor v10, Roller v7</strong></p> <p>Corrected mistake on motor block</p> </li> <li><p>Expanded the hole for the GT2 Timing Pulley since it wouldn't fit.<br/> Added additional roller</p> </li> <li><p>Uses 688ZZ ball bearings (OD 16mm, ID: 8mm, width: 5mm)</p> </li> </ul>