Motorized and higher-torqued filament and yarn spooler.

thingiverse

Designed to fit with the common yellow motors that come in toys that you can buy on amazon. The gear ratio is 1:0.5, so a little higher torque. there are also screw holes and pieces for holding the sides together. there will be updates such as a guide to the material does not getting tangled. to connect the motor, I recommend using some glue or tape, as it may be loose depending on the printable detail of your printer. **--UPDATE 3-4-2022--** added a small filament guide wheel for allowing the filament to move at 90 degrees without breaking. it uses small bearings with 35 mm diameter, 11 mm height, and 15 mm bore dia. it is also screwable and has a built-in spring. I recommend printing with a low speed since it the spring can cause clogs. I also recommend a slower fan setting.