Motorcycle Stand

prusaprinters

Couldn't find a stand that worked for my bike, so I designed my own.Print both left and right stand parts and fit them into the bottom of the frame tube near the foot pegs. Build an L shaped wood support for the plastic stands to sit on. I used one 2x6 sandwiched between two 2x4s. Make sure to add a handle that's at least 4 feet long. Place the wood support flat on the ground under the bike and slowly lift the handle while aligning the edge of the 2x6 with the plastic stands. Then just continue to lift up on the handle until it's vertical.The stands takes 90-95% of the weight of the bike off of the wheels, raising the rear wheel about ¾" off the ground. Useful for performing maintenance or storing for the winter. I've used this for 3 winters now with no issue. Occasionally the stand will get stuck in the frame, and I will break it off and pull the rest out with a screw, and print another one. I've done my best to size it properly to prevent this while maintaining strength.Printed with 4 perimeters and 50% infill.