Motorbike fun design PART 5

thingiverse

Here are the final parts for the chopper. Oil tank, oil cap, Callipers L & R front and one rear and the Carbi cover. All parts are printed to 1.5 times the size of the stl's. Everything was printed at 15% fill except the oil cap, which I did at 99%. The oil tank needed trimming a bit to make it fit, just where it contacts the frame. The Carbi cover had to be trimmed some off it to allow it to slot in better. The front callipers have to be glued on; all that is needed is a drop of super glue. Other than that, everything should just slot in. I hope you enjoy the Chopper. If you have any questions, just ask. If you think any of the parts need changing, let me know. All the parts to build the whole bike are located over the five sections of Motorbike Fun Design. I am currently making a new part for the back guard because I dropped the chopper when I was fitting the oil tank and broke the back of the guard. I will try to scab a part on to it rather than printing a whole new rear section. That is why I haven't posted a picture showing the complete bike yet; once I do, I will. Please let me know if you make one. Thanks again. Note: I thought it would take some time, but not this much. I think I have spent close to 80+ hours on this. Print settings: Printer brand is Up! Printer model is Up Plus2 Rafts are Yes Supports are Yes