Motor guard, TBS immortal-T antenna and DJI FPV antenna holders for Armattan Gecko 4 frame

thingiverse

Hello, I wanted to make motor guards and holders for the DJI antennas and TBS immortal-T antenna for my new Armattan Gecko 4 drone. I found a good model for the guards (https://www.thingiverse.com/thing:3379481), but it was not high enough so I stretched it up a little bit. Now it works great for the Gecko 4 frame with the Armattan Mini Titan Oomph 1407/3650kv motors. Also made the V2 version to attach the guard from the bottom of the frame main plate, works better since this way the motors attached directly to the frame but not to the TPU layer. The other two things I also modified from the DJI antenna holders model (https://www.thingiverse.com/thing:3919933) and the TBS immortal-T antenna holders model (https://www.thingiverse.com/thing:3400170). The original immortal-T antenna holders were too short so I had to extend them down a little bit to avoid the antenna touching the frame. Some minor modifications were made to the DJI antenna holders as well to fit the rear posts of the Gecko 4 frame. Also made the V2 version to make the T-antenna closer to the main plate.