Mossberg Shotgun Rear Notch Sight

thingiverse

I developed a knack for pulling the trigger before the gun was aligned on target, but this corrected it! This small rear notch sight is designed specifically for Mossberg shotguns to provide a point of reference for lining up the bead with the barrel when engaging steel targets or distant fliers with a tight choke. The height of the notch is precisely calibrated to match most non-tactical front bead and fiber optic sights, ensuring accurate alignment. On average, it takes less than 10 minutes to print this sight using under a meter of filament. Additionally, you'll need two cap-head rear sight screws specific to your shotgun, which can be found at Ace Hardware in their "Gunsmith" section. Be sure to verify that these screws fit properly, as I disclaim any responsibility for the attachment method and potential damage that may result. Keep in mind that overly long screws may protrude into the action and hinder bolt cycling.