Mosquito / Dragon Hotend E3D V6 Mount

thingiverse

Mosquito and Dragon Hotend Mount. It also fixes the clogging problem of the Dragon Hotend as it has a design flaw at the PTFE tube connector. The PTFE tube has to be cut straight going into the heatbreak on the Dragon. Both hotends have their pros and cons. The mosquito needs hotend temperatur calibration as the thermistor and heater are too close together. Therefore being too cold at the nozzle. Installation of the Mosquito requires to alter the V6 slightly with Dremel tool on the bottom towards the heat block. Cut a little space all around on the cassy. The mount itself will hold it just fine. It needs to be installed sideways to the fan!!! To prevent over-cooling. You may have to increase the nozzle temp by 10-15 degrees for all prints if you keep the stock left fan. Cooling is superior this way because the space is different on both sides of the mosquito providing different airpressures and will cool the heatbreak actually better this way. Print quality is amazing. Use a drop of superglue in the little side holes of the mount to ensure there is no movement of the PTFE tube.