Mosaic Palette 2 Teflon tube mount for Wanhao i3 Plus

thingiverse

This is a tube clip for the Mosaic Palette 2 designed for the Wanhao duplicator i3 Plus. Whenever I'd use the built in clip the extruder would always end up pulling the velcro loose and jamming the print. The Palette was unusable on the i3 for me without this mod. It holds the tube in place and also has a second clip to keep the tube from getting to sideways. The tolerances here are pretty tight. If the filament is not exactly over the extruder, friction between the filament and the side of the extrusion intake can cause disastrously under extruded parts. I included the fusion 360 file in case you need to move the hole around. Normally I would not post the source file on a remix, but this was far more inspired by Carsten's part than mixed from. I modeled it from the ground up, and just used his model for inspiration and measurements. I recommend printing with 100% infill with the flat part on the build plate, but supports are going to be a PITA here no matter what you do. I'm hoping to use my ugly one to print a better one with soluble supports once I finally get the Palette all dialed in.