More Darth Vader Dice Towers

thingiverse

Need Imperial Power? I present to you more Darth Vader Dice Towers. To print these, you must adjust the support settings. Alternatively, see my "Darth Vader Dice Tower - No Supports Needed!" (Thing:3414880) if that's your preference. The Darth Vader Head is designed for use with 17mm dice and below. Your results come directly from the mouth of the Dark Lord himself. You can either block the supports inside the dice tower or instruct your slicer to set a minimum support angle of 70 degrees. With filament properties dialed in, it will print without issue. The Darth Vader bust lets you receive results from the Dark Heart of the Sith! It prints similarly, but is still under development. Printing at 75% size works for dice smaller than 17mm, while a full-size print accommodates 17mm dice as shown in the images. To minimize support cleanup, block supports on the central area or set your slicer to a minimum support angle of 70 degrees. Designed and printed using the M3D Promega Revised Darth Vader Bust - 3/21/2019