Mordheim - Miniature City

thingiverse

I hope you find these miniature buildings useful!Remember though, It is basically a lot of square boxes with tiny differences :b The smallest building is 1x1x1cm plus a triangular roof. Everything is then scaled to fit this size. This means that each level of a building is 1cm.You will find lots of different "normal" buildings with a few special-made buildings, like the Rock. Print Settings and recommendations from a noob:You might want to split a few of the more "advanced" models as the overhang will probably kill the print.Do not use supports in general as these building are too small - just split the model instead of glue it together afterwards.When printing a lot of the same building I recommend using a brim around each building.. Also, if the print fails and you didn't use a brim - try that. I set the plate to around 65-70 degrees.If you need to print a few hundreds (or even thousands!) I recommend to use the proper filament color from the start. Spraying these little buildings is a mess and takes time.Again, hope you find these miniature buildings useful!