Moon Goat Vista VTX and Antenna Mount

thingiverse

The rear 20x20 holes on the Moon Goat have been drilled for M3 hardware which is odd considering most 20x20 electronics including the Vista use M2 hardware. This mount allows you to cleanly use the correct M2 hardware for the Vista. This mount will let you install and remove the Caddx Vista or Nebula with antenna as a single unit. It's tough construction wont allow the Antenna to rotate in a crash unlike many other designs. There is a small channel that runs underneath the VTX that allows for clean, out of site wiring. You will need 4xM2 and 2xM3 nuts and screws. The nuts get pushed into the TPU to allow the screws to thread in. IMPORTANT: Be sure to print this with supports touching the build plate only. You want to avoid support being printed inside the antenna tube as it is very difficult to remove cleanly enough for the antenna to fit inside.