Monoprice Select Mini V2 - Genuine e3d V6 mount. Single piece. Stock fan.

thingiverse

UPDATE: See below... The Monoprice Select Mini V2 comes with a cloned V6-style hot end. If you install a genuine e3d V6 hot end and nozzle in the stock mount, you find yourself about 5mm away from the bed normally. There are many ways to overcome this gap and other prints. However, I decided to create one simple piece to mount the genuine e3d V6, which uses all the rest of the stock front part and fan without spacers or any modifications needed. I modelled the original back part of the mount, then lowered it 5mm and reduced its material slightly to make it printable without supports. Best printed in ABS, although you could probably get away with PETG up to a point. This is my first attempt at using Fusion 360, thanks to all the helpful YouTube videos out there! Also included is the model I made of the stock mount with everything in its original position, free for you to chop up and do what you like with it. UPDATE (17 Dec 17): I've updated this design a little. I got rid of the bottom half of the 'ring around the heat sink, no need for it. It can also be prone to melting. Also, I decided that 5mm was too low, so reduced the amount down from stock to 3mm. This saves having to crush the bed down too much.