Monoprice Select Mini (MPSM) first layer level calibration print

cults3d

I was approached about excellent calibration prints for the Monoprice Select Mini, and beyond the standard (Benchy, etc.), I stated that all I use is a first layer test, since most of the time that's the majority of the struggle. Couldn't attach the file to a Thingiverse direct message, so thought I'd just post it if anyone else was interested. How I created it This is just a 100x100x0.25mm block sliced in Cura with no top or bottom layers and a 20% infill. This results in two shells and one layer of infill which gives you a fast print that shows you the stability of your bed levelling. I was also going to promote this as "DIY fishnet" but I think I'll leave that to Sexy Cyborg