Monoprice Select Mini Leg (No Baseplate)

thingiverse

So this is a specific solution I came up with after my board died and I replaced it with a Ramps 1.4, which turned out to be a lot taller than my Mini could sit flat on its base plate. To solve this problem, I designed this adapter to slide onto the inside of the front and back steel plates, allowing my Mini to rest there comfortably. UPDATE: V2 of the legs is now available! I've added a small lip to help prevent them from sliding off once they're in place, but it's still unclear whether this will be effective. Additionally, I increased the height by 1cm for better clearance around the RAMPS board and reduced the space within the clip itself, making it slightly tighter. If you find the hook too loose, keep in mind that your material may shrink over time, which could affect its tightness. To prevent this, try lining the inside of the feet with a piece of painter's tape to stiffen them up. Print Settings: Printer: Monoprice Select Mini Rafts: No Supports: No Resolution: N/A Infill: 15% Notes: You can print this adapter on its side without any supports for the lip overhang.