Monoprice Select Mini Glass Bed Holder

thingiverse

Hold a 5x7 picture frame glass, approximately 2mm thick, evenly on top of the print bed. PETG or ABS must be used for printing; avoid PLA, as it may deform - personal experience with PLA has not been conducted yet. There is sufficient clearance to print across the entire print bed without interference. A minor cleanup and sanding were required to fit the glass perfectly, but with some effort, a smooth fit should be achievable. Tinkercad model available Print Settings Printer: Monoprice Select Mini Rafts: None Supports: None Resolution: 0.175 Infill: 50% Notes: Printed using eSUN PETG Sliced with Cura 2.4 To print this part, you will need to position the printer at an angle due to its length of 145mm. A brim was also printed to prevent warping on the ends; previous prototypes had severe warping issues in that area.