Monoprice Select Mini 60mm shroud

thingiverse

I saw dual 30mm fans cooling the hot end and the print, but I thought the stock method with one fan plus ducted airflow could do the same job with a larger fan. So I doubled the fan size and designed an adapter using nBurn's stock shroud model. This is a direct replacement for the existing shroud. You only need to unclip the old shroud and fan, then clip in the new one and wire up the fan. This was designed for the V2, but it should work on the V1 - I just haven't confirmed this yet. Orientation worked best with the 60mm facing up and the 30mm side flush with the print bed. It took 7 hours to finish, which could be reduced if you're into tweaking settings. I used the fine print settings in CURA 4.0.