Monoprice (MP) Select Mini Side Panel for X Axis Support

thingiverse

MP Select Mini Side Panel for X Axis Support ==================================================================== Original Post: https://www.thingiverse.com/thing:1759301 ------------------------------------------------------------------------------------------------------------------------ **My Design:** Instead of inserting a fan on the side, I blocked that out and added a hole to reroute underbed wires. *Links for 6mm hardware: 6mm Bearing: http://amzn.to/2cHacJL 6mm Shaft: http://amzn.to/2cid1mb* *UPDATE:** For now, I am limiting this to the 6mm version due to revision reasons. *This is an X gantry support system for the Monoprice Select Mini (Malyan M200 ) designed to accomplish two main things: *1) If your X gantry tends to droop and bed leveling is difficult, this guide rail will immediately correct that and ensure the Gantry stays parallel to the bed and perpendicular to the Z axis.* *2) It will reduce or eliminate oscillations of the gantry that cause ringing and other visible artifacts on your prints especially at higher print speeds.* *INSTRUCTIONS: This design comes in two variants: a bolt over pylon that attaches over the existing side panel with slightly longer screws, and a full replacement panel with a 40mm cooling fan. A linear bearing holder screws onto the end of the X-Gantry using original screws, then a bearing is zip tied snugly in place. Finally, a 300mm linear shaft is slid through the linear bearing and clamped into place in the support pylon. The following links will take you to the bearing and linear rail needed to complete this modification: Credit MP Select Mini X Gantry Support System by FDM_Guru for the original design I based this on.