Monoprice Mini Delta Riser Feet

thingiverse

The stock rubber pads for the MP Delta measure approximately 4mm in height. To enhance airflow beneath, especially when adding a fan to the base, I opted for slightly taller pads. These new pads attach to existing holes and can be secured using M3x8mm hex head screws, which I substituted for the original screws. For the rubber feet, I repurposed leftover components measuring 21mm x 15mm x 11.5mm in height, accompanied by M5x8mm screws and a square nut that slides into a recess within each foot. This modification adds about 21mm of clearance, effectively increasing the open area below by nearly an inch. An additional version features strategically placed slots for ziptying power or USB cords, providing strain relief. Given that the power connector is attached directly to the control board, I was concerned about potential damage if the power adapter were dropped or mishandled. These pads are compatible with my Anet A8 printer but can also be used on the delta itself.