Monoprice Maker Select V2 Rear Cable Conduit Resized/Reversed

thingiverse

I resized the back plate to fit my z-brace mod, shortening it and reversing it in case I had routed cables to the opposite side. To secure it, I filled in screw holes on each side instead of using double-sided tape. You may need to enlarge the hole slightly as I made it too small. I opted not to redo it. I decided to publish these files in case anyone else was experiencing a similar issue. When replacing the removed screw, use a longer one, probably 5/6mm, to mount the "plate" to the back securely. The files included are: 1x Resized back plate with screw hole 1x Resized back plate without screw hole 1x Resized Cover 1x Resized and Reversed back plate with screw hole 1x Resized and Reversed back plate without screw hole 1x Resized and Reversed Cover For printing instructions, please refer to the original design on Thingiverse: https://www.thingiverse.com/thing:2486494. The shrouds will need to be printed flat side down after rotation. I did not include this in the STL file. **UPDATE** I recently fixed a mistake I made earlier by reconnecting the two tabs that were disconnected in the Reversed Conduit Shroud. This was due to an error during mesh merging, and it's now uploaded for you to use. **Another Update** To cater to different setups, I've added six new files named similarly but with one-sided wire holes on each side. These are labeled as "OneSided_A" and "OneSided_B." Choose the one that suits your needs if necessary.