Monoprice Maker Select v2 Glass Bed Corner Clamps

thingiverse

Remixed AustinGeorge's Duplicator i3 clamps to fit my Monoprice Maker Select without having to drill parts. Downloaded his version, edited in Microsoft 3D Builder to fill the Wanhao-spaced hole, measured a 5.45mm from either edge circle of the same diameter as his, and printed four. Update: I've had these or a few weeks now and really enjoy them. Here are some notes to consider... +Don't crank down your screws too much or it'll chip the glass. I had some liquid rubber I used to coat the tip of the screw just in case (not reflected in picture) +Placing this between the heated bed and the locknut should satisfy the safety concerns with Wanhao's recall (Monoprice Maker Select is the same machine, different logo). +If I were to do it again, I might consider making it a bit taller, so that the screws aren't so close to the buildplate, but this is 100% functional Update 2: Taller version (v1.2) Added a version (1.2) that is 2mm taller than the previous one to accommodate buildtak+silicone+thicker beds. CAUTION: Consider the height of any add-ons around your nozzle (Lasers, Hall-effect sensors, DiiiCooler, etc). The 2mm taller may cause difficulty with clearance between the two. Print Settings Printer: Monoprice Maker Select Rafts: Doesn't Matter Supports: Doesn't Matter Resolution: .2 Notes: I used 50% infill just to give it a little more strength than the standard 30%. I don't see any infill information on the original build, so it's up to you!