Monoprice Maker Select V2.1 Hot Bed Cable Bracket

thingiverse

This bracket helps keep the hot bed wires from bending by keeping them elevated off the build plate. It also keeps these wires low and away from a rear-mounted part cooler when the extruder is near the back of the build plate. This bracket was designed to work with the RepRap Champion Y Carriage Plate Upgrade for the Monoprice Maker Select / Wanhao Duplicator i3. To install this upgrade: Place the bracket between the Y-carriage plate and the hot bed, making sure the clips are pointing down near the hot bed wires. Hook one clip on the outside of the Y-carriage plate and slowly lift the end until the other clip clicks into place inside the Y-carriage plate cutout. Some trimming may be necessary due to the tight fit. Once in place, lay the hot bed wires on top of the bracket and use a small zip tie through the provided holes to secure them in place. Be sure the eyelet of the zip tie is on the upper side of the bracket to prevent it from hitting the frame.