Monoprice Maker Select Bigger Spool Holder v2

thingiverse

The spool holder that came with my Monoprice Maker Select V2 was woefully inadequate for holding the spool I also obtained from Monoprice. Therefore, I designed a replacement that's properly proportioned to accommodate the spool. It securely fastens onto the original nut. STL files for the nut are available in case you misplaced the original: https://www.thingiverse.com/thing:2333352 I had previously created an older design, version 1, which can be found at http://www.thingiverse.com/thing:1791166. Notable changes from this earlier iteration include thinning down the tip of the holder from 45mm to 25mm and reducing the bulk of its length from 37mm to 20mm. The last 10mm bevels outwards from a 20mm diameter to 37mm, ensuring that the holder still securely fastens onto the frame. A bevel is also incorporated into the design to maintain an overhang angle below 45 degrees, allowing it to be printed without supports. Photos by dubyuhtee can be viewed at https://www.thingiverse.com/dubyuhtee/about