Monopoly Community Chest Card Holder

myminifactory

Monopoly Community Chest Card Holder This card holder is designed for use with the standard version of Monopoly and should fit other editions as long as the card sizes are the same. It features thumb slots on each end and a groove running down its length to accommodate a rubberband that keeps cards in place while not in use. Disclaimer Most people print at a layer height of 0.2mm, so I used that setting for this holder. I also used cheap filament that came with my printer to avoid wasting my better-quality Hatchbox filament. The result is lower quality around the letters. This holder prints in one piece, requiring tiny supports for the rubberband groove. With finer print settings and high-quality filament, it will look cleaner. The walls on the ends are very thin at only two 0.4mm layers wide, but they won't break unless you abuse them.