Monopod Tripod Conversion

prusaprinters

<p>This is designed to add a tripod base to a Dynex DX-SW040 Monopod. This design may work with other monopods, but I only own the one monopod so This unit is designed for the Dynex.</p> <p>The slots for the legs are for 1/2 inches (12.5mm) dowels with a hole to add a screw to lock the dowel in place. I used a 10" Long Dowel (25 cm)</p> <p>After printing and support removal a 1/2 Inch drill bit was used to clean up the holes so the dowel will fit.</p> <p>The Monopod is then Attached with zip ties</p> <h3>Print instructions</h3><p>I printed the original using a 0.6mm Nozzle, but a .04mm Nozzle would work just as well.</p> <p>I suggest using 4 perimeters to increase strength as this part supports a very top heavy load.</p>