MONO X VOC FILTERING SYSTEM - Remixed Exhaust

thingiverse

After setting a print on my Anycubic Photon Mono X with the Right and Left Exhaust pieces to print, I come back in the morning to see it had failed. So i decided to split the exhaust ports into 2 pieces. Now i was able to print the Partial bottom files on their back (On the build plate) with a few supports that i moved away from the object so the base doesnt blend into it. I then did the same thing with the 2 top sections, but together on 1 plate as seen above., I was able to make all of these prints at 1 hour and 20 seconds each with modest/slow settings. So overall taking 1/3'ish the time to print these components. Thank you JVJV for the wonderful project. I will be posting a make shortly. I printed these in Sariya Tech Fast "Navy Gray" For whatever reason, my things always give the 404, so if this happens, click the files tab and grab them one by one. Then i set the 2 pieces on a piece of metal, and with a brush, paint on a little bit of resin, and cure with UV light, and so on and so fourth until the seam is covered up. See above image for my completed part.