Monitor Stand

thingiverse

A four-part monitor stand designed specifically to hold a 24-inch monitor features an adjustable tilt. For users seeking alternative heights, another model is available that allows for different height positions on the Vesa Mount. To print this base in one piece, you'll need 350mm of print height and a 300mm bed. This base was printed with a 0.8mm nozzle, two outer layers, and 0.25mm layer height, resulting in an infill of 50% using a triangular pattern. The bolt and grapel were also printed with a 0.4mm nozzle, five outer layers, and 0.2mm layer height, along with an infill of 70% using a triangular pattern. The Vesa mount was printed with a 0.4mm nozzle, three outer layers, and 0.2mm layer height, using an infill of 50% with a triangular pattern. If you plan to use this part, make sure to use high-quality filament and settings that meet or exceed the ones I used – in my case, the stand held 20 pounds for 15 minutes without issue. For assistance with your project, visit my website at www.bitdrafted.com.