Monitor camera mount

prusaprinters

<p>This clips onto the top of a computer monitor, allowing you to mount your camera for a convenient slightly raised vantage point.</p><p>&nbsp;</p><p>You need some parts to actually mount the camera:</p><ul><li>A ball head, widely available from amazon/ebay/aliexpress et al.</li><li>A ¼"-20 screw; I used one that was 25mm long but anything above 12mm or so should do.</li><li>(optional) a 25mm/1" penny washer.</li></ul><p>Place the washer on the screw, poke it through the hole in the 3d printed part, and screw on the ball head.</p><p>&nbsp;</p><p>This is probably overbuilt, and should be good for a fairly large camera (much larger than the old point&amp;shoot I used in the pictures, I was using my camera to take the picture so couldn't show it with a proper camera), but a 70-200 f/2.8 lens might be a bit too heavy though.</p><p>A wide angle (35mm equivalent and wider) lens should give nice framing, depending on your desk setup.</p><p>&nbsp;</p><p>Print instructions:</p><ul><li>Print with the top side facing down; a coarse layer height will be fine.</li><li>requires a 110x130mm print bed with 70mm height.</li></ul>