Mold for Dice Mold

thingiverse

This is the perfect mold for making cap dice molds! Designed to be reusable, and reduce the amount of silicone required (only 30 mL). How to Use: 1. Use double-sided tape or a small amount of sticky tack/modeling clay to stick the die to the lid. Make sure to leave space for the notches on the tube. 2. Cover the face of the tube with the notches, and the lower exterior of the tube with vaseline. This will help to prevent any leaking and make it easier to remove the tube from the base. You may also find covering the interior of the tube helpful for removing the silicone mold from the tube. 3. Carefully insert the tube into the base. 4. Mix up 20 mL of silicone (10 mL of part A with 10 mL of part B). Follow the directions on the bottle. Very slowly pour the silicon mix into the tube. Make sure the die is entirely covered. Allow the silicone to set. 5. Once the silicone has fully set, gently twist and pull the tube out of the lid. 6. Push the silicone mold out of the tube. Clean up rough edges, and remove any tape/clay. 7. Insert the mold into the tube so that the base of the silicon mold is sitting on the tube notches. 8. Cover the entire face of the silicon mold including notches with vaseline. Do not cover the dice face with vaseline. 9. Mix up 10 mL of silicone (5 mL of part A with 5 mL of Part B), and slowly pour it into the tube. Allow the silicone to set. 10. Remove the silicone mold from the tube, clean it up, and get ready to make some dice!