Modules with better alignment and lips for netpot

thingiverse

02/11/2020: Added a base module with 4 M5 screw holes. This module is designed for easy attachment to a bucket lid or even a wooden base on top of the bucket. 02/10/2020: Introduced a reservoir module featuring a 3/4" BSP thread, allowing for quick hose connection for effortless maintenance and modification of the entire tower system. All credit goes to Archipelagourbanfarms for their original design (https://www.thingiverse.com/thing:2403922). I was thoroughly impressed by this design and had to give it a try. However, as a perfectionist, I noticed that the top section was slightly off-center with a noticeable step. This minor flaw bothered me. To address this issue, I redesigned the module, incorporating one to three slots along with a lip to securely hold the net cup once plants grow larger (as seen in this example: https://www.thingiverse.com/make:450646). Important note: If you plan to print modules with lips, do it upside down to avoid any potential support issues. I hope you enjoy these redesigned modules and wish you continued success!