Modular Toy Biplane 3D print model

cgtrader

This toy has been under construction for approximately one month, with frequent adjustments made to achieve perfection. The propeller and wheels can be manipulated freely - it's even feasible to suspend them above a fan, vent, or strong gust of wind and observe their spinning motion; however, it is not recommended to toss this model about as it could lead to breakage despite being built with a sturdy design. At around 30 miles per hour out the car window, I successfully achieved liftoff while ensuring the wings remained intact. Once completed, the plane stands approximately 8 inches tall with a wingspan measuring roughly 10 inches in diameter. Alternatively, users may choose to print this model at 75% scale to obtain a significantly smaller and even more adorable replica - in fact, I personally find this size preference more charming than its larger counterpart. The following materials will be necessary: * PLA or a similar filament (preferably silver/pewter for the engine pistons; any additional colors desired may also be incorporated - I usually print mine with two-tone colors but users can opt for one or multiple colors if they prefer) For the smaller, 75% printed design, nails of size 1/16 x 0.5 inch will suffice instead. Something should also be available to trim and/or clean the materials if needed - possibly using scissors, a sharp blade, etc. Now let's move on to assembly guidelines for your new airplane toy: * Use super glue liberally around both struts as well as slots; gently push the upper portion until snug.