Modular Pliers Holder

prusaprinters

<p>This modular pliers rack is a variation on a simple holder I printed for my own use.</p> <p>This version features modular tool inserts to allow customization of the rack.</p> <p>There is also a small parts tray in the base to keep those little bits that roll around your desktop under control.</p> <p>I am providing the base rack in a number of sizes. They are all the same except for the number of tool bays.</p> <p>The number bays is limited only by the height of your build volume!</p> <h3>Print Settings</h3> <p><strong>Printer Brand:</strong></p> <p>Creality</p> <p class="detail-setting printer"><strong>Printer: </strong> <div><p>CR-10S</p></div> <p><strong>Rafts:</strong></p> <p>No</p> <p class="detail-setting supports"><strong>Supports: </strong> <div><p>Yes</p></div> <p><strong>Resolution:</strong></p> <p>.2mm layer height</p> <p class="detail-setting infill"><strong>Infill: </strong> <div><p>20%</p></div> <p><strong>Notes:</strong></p> <h3>Rack Base</h3> <p>The tool rack prints on its "end" with supports.</p> <p>You want supports "everywhere" not just "from build surface."</p> <p>That helps keep the slots open and the struts clean.</p> <p>My best results were using the Cura slicer with "roofs" and "floors" on the supports.</p> <p>I also had good results with Simplify 3D.</p> <h3>Inserts</h3> <p>The inserts should be printed solid.</p> <p>I did this by setting the number of top layers to something large like 99.</p> <p>I also recommend printing these with a bit of a brim since they are flat and can warp easily.</p> <p>I've printed these in .2mm layers height and .16 and both worked well. Just a slightly cleaner chamfer with the finer layer height.</p> </p></p></p> Category: Organization