MODULAR NAS FOR 2.5 INCH DRIVES FITS RASPBERRY PI 4 AND NANOPI M4V2

thingiverse

3D MODEL DESCRIPTION This is a frame designed to build a NAS out of a Raspberry Pi 4 or a NanoPi M4 and several 2.5 inch laptop drives. You can use SSDs or HDDs. The design is modular, so you can stack as many drives as needed. Here's what you'll need: Raspberry Pi BOM: https://docs.google.com/spreadsheets/d/1MBA4_MIdntRmM5Id4CDIesFzkvpFFsqoc3ilLQvXM-4/edit?usp=sharing NanoPi BOM: https://docs.google.com/spreadsheets/d/1x4bQ7UW-Uw923PWbaMt8JPkXt-k_j3668qdDlzOfB_M/edit?usp=sharing Raspberry Pi Amazon shopping cart: https://www.amazon.com/hz/wishlist/ls/1PSLHA6H4BRSU?ref_=wl_share Nano Pi Amazon shopping cart: https://www.amazon.com/hz/wishlist/ls/3HS6QZTXP0MZ0?ref_=wl_share Buy Nano Pi M4V2: https://www.friendlyarm.com/index.php?route=product/product&path=69&product_id=268 Full Instructions: https://docs.google.com/document/d/1-8nUtfmckd7sXCuuApqggEjFFnbgGanFfqvVExsPdj8/edit?usp=sharing Print: (1) Either the Raspberry Pi mount or the NanoPi mount. (2) Clips for each drive. If you have 4 drives, print 8 clips (2) Risers (NanoPi or Raspberry Pi) (2) Frame Stabilizers (1) Fan mount (for Raspberry Pi only) Assemble the drive clips onto each drive by sliding them on from the bottom and inserting the protrusions into the screw holes. Stack the clips together to form a single unit. Attach the Raspberry Pi by ensuring the indentation in the printed piece corresponds to the position of the SD card slot on the Pi. Plug the fan into pins 2 (positive) and 5 (negative) of the Pi. If using the NanoPi, note that the direction with respect to the frame tabs is crucial. The side marked BACK should face towards the USB ports. Slide the risers onto the Pi mount and then join the two assemblies together. For more detailed instructions and setup information, check the link above.