Modular Marker Organizer

prusaprinters

<p><strong>Updated design: </strong><a href="https://www.prusaprinters.org/prints/154249-parametric-modular-honeycomb-organizer"><strong>Parametric Modular Honeycomb Organizer</strong></a></p><p>I gave my brother 216 alcohol markers for Christmas, and, while I really like Geeky Faye's design, it was going to take too long to print 9 sections at ~1 day apiece, so I made a few modifications:</p><ul><li>Removed the GFA “watermark” on the bottom. This was necessary in order to guarantee good bed adhesion.</li><li>Removed wall mounting holes, again to improve bed adhesion.</li><li>Removed magnet holes: I'm optimizing for print time, which means using layer heights well beyond 0.2mm.</li><li>The back thickness was reduced so that it could be completely solid.</li></ul><p>Additional notes:</p><ul><li>These things use <i>a lot</i> of filament. A single set requires just under 1kg. Use a full spool.</li><li>I used some fairly 'aggressive' settings in combination with a brim to guarantee good bed adhesion. You will need a decent utility knife or deburring tool to clean it up.</li></ul><p>I've included the Blender files I used to make the modifications. Note that some additional optimizations that could be made to dramatically improve print times and material usage. Specifically, setting all of the wall thicknesses to 1.6mm (instead of 3.2mm inner and 1.85mm outer) would eliminate the need for gap fills and should support both 0.6mm and 0.8mm nozzles.</p>