Modular Flasks V6.8 (UNTESTED) possible improvements

thingiverse

I've had these v6.8 files on my computer for over two months now, and someone just reminded me about them. I haven't had the time to try out these new designs yet, so be warned! However, this module might offer an improvement over the previous ones. CHANGES: A) The ribs are thinner, allowing for a smaller handle piece and less shrinkage. B) The corner pieces have slots, eliminating the need for drilling holes. C) Follower patterns fit under the corner pieces, using 3mm pins to locate. These follower wedges make it unnecessary to dig out corners when sand casting. To use these follower wedges, place the side of the mold on a bench with the wedges underneath the corners. Fill the drag with sand and flip it over. Instead of digging out the sand to reveal the corners, simply remove the plastic follower wedges - you'll need one wedge per corner. This module hasn't been tested yet, as I've been short on time. However, I'm releasing these files in case someone wants to be adventurous! Please let me know how it goes. If you're looking for designs that have been thoroughly tested and work well, try version 6.7 here: https://www.thingiverse.com/thing:4033453