Modular Dremel tool holder

thingiverse

Yet another one of these systems! Based on six tool-wide, dovetail-linked small modules, this system offers a wide variety of combinations that can be disassembled and reorganized with ease. The front and rear blocks can receive containers (04,05,06,08,09) to store shankless tools, while blocks specifically designed for drill bits (10,11,12) are also available. A special block for holding 4mm hex screwdriver bits (20) is present, which can be supplemented with two hooks (21,22) for holding Es120 type screwdrivers. ### Assembly and Disassembly The pieces were originally designed for 350µ layers, resulting in tight dovetail tolerances that make them difficult to disassemble. To dismount easily, use the edge of a table as shown in the image, and if necessary, employ a rubber hammer. When inserting or removing pieces, pay close attention not to slant them. If you print the pieces with lower layer thickness, they will be easier to manipulate. Edge cups (04,05,06,08,09) have male dovetails that can only fit one side of the modules, while the inverting module (02) has female dovetails on each side - a unique feature compared to regular modules. The objects are designed with welded parts created from 4-sided meshes. If your modeller allows selecting faces based on junction continuity, you can easily extract the dovetails and inner modules to create your own fitting holders.