Modular Battery dispenser for pegboards (to suit AA batteries)

thingiverse

The design is inspired by LarNil's work, found here: http://www.thingiverse.com/thing:605854. It also incorporates pegboard connection pins from Saadli's dispenser, available at: http://www.thingiverse.com/thing:495871. The system is modular in its design, allowing it to fit into a standard 1" hole pattern and ~4.6dia holes on a pegboard. The base unit can hold up to 18 AA batteries, while the extension module holds 16 each. Additional extensions can be added as needed. A cap can be placed on top for a finished look, if desired. UPDATE: An additional set of components has been created to accommodate 1/4" pegboard holes, including a new base, extension, and pin. Instructions: To begin, print one base unit and as many extensions as required. No supports are necessary, but a raft is recommended for the extension module to prevent it from toppling over before the two halves are joined at the top. Each base requires two pins, while each additional extension requires an extra pin. The cap can be used on both the base and extension modules.